There are a lot of energy-saving tips out there that claim to help you reduce your energy costs and increase your financial savings. Unfortunately, they’re not all true. Here are five of the most common energy-saving myths.
In summer, a ceiling fan cools people through air movement. Running it in an empty room wastes electricity. The way a fan works is by circulating the air in the room, which when it makes contact with skin, makes us feel cooler. A fan does not lower the room’s air temperature. In winter, a low-speed reverse setting can help redistribute warm air near the ceiling. A better option is to turn the fan off when you leave the room and save on the energy cost. See DOE’s Energy Saver guide.
You might think that by walking into a cold room and cranking the thermostat up to 88˚F is going to make the room heat up faster. For a single-stage furnace, raising the setting does not increase its heating output. The thermostat calls for heat until the room reaches the set temperature. Multistage and variable-speed systems can respond differently, and heat pump controls may call for auxiliary heat. Follow the equipment’s recommended thermostat settings. In fact, you may waste energy by forgetting to reset the temperature once the home has been heated. Instead, simply set the thermostat to your ideal temperature. The same principle applies to cooling a house. See DOE’s heat pump thermostat guidance.
This is a very common energy-saving myth. Turning a computer off during long idle periods reduces the energy it uses. You can also take advantage of built-in energy-saving features such as the “sleep” function that essentially puts your computer to sleep when not in use and wakes it when you go back to it. Again, this saves what would otherwise be a lot of wasted energy. See ENERGY STAR computer guidance.
Closing registers in a central forced-air system can restrict airflow and increase duct pressure. It can strain the system and increase energy use. A designed zoning system uses controls and dampers selected for the equipment; it is a different arrangement from closing registers by hand. There’s no point in shutting off vents and registers in an effort to save energy – you’re probably doing the opposite instead. Use thermostat settings suited to your equipment. Heat pumps need compatible controls for efficient setbacks. See DOE’s home energy guidance.
An efficient dishwasher can use less hot water and energy than hand washing, particularly when dishes would otherwise be washed under running water. Results depend on the appliance, cycle, load and hand-washing method. Many modern dishwashers have energy efficiency settings that use less water and energy to keep costs down. Run full loads, scrape instead of pre-rinsing, and use air drying when available. See ENERGY STAR dishwasher guidance.
This content was originally published by the Residential Energy Services Network (RESNET) here. This content has been republished with the permission of RESNET. RESNET is the independent, national nonprofit organization that homeowners trust to improve home energy efficiency and realize substantial savings on their utility bills. RESNET’s industry-leading standards are recognized by the U.S. Department of Energy and the U.S. Environmental Protection Agency, among others.
Updated content · November 18, 2026