Pools that have been out of commission for the winter are likely to stay that way unless we turn the heat on. That can get expensive. Stop for a moment and think of how many blow dryers, computers, cooking appliances, lights and people there are in your home that add to the cooling load. A conventional air conditioner moves that heat outside. What if some of that heat could warm your pool or help preheat your domestic hot water instead?
A ground-source heat pump uses relatively stable underground temperatures to heat and cool a building. In cooling mode it normally rejects heat to the ground loop. In a system designed for heat recovery, some of that heat can go to water that needs warming. The opportunity is greatest when cooling and water heating overlap. If the house is calling for little or no cooling, the pool may need heat from the ground loop or a separate heater.
There are a few different ways that a pool is normally heated: fossil fuel, electric resistance, solar, or a heat pump. Solar pool collectors can be a good fit when the site gets enough sun, but output depends on the weather. Gas and electric resistance can supply heat without sunshine; operating costs depend on local energy rates, equipment and use. Resistance heating delivers about one unit of heat for each unit of electricity at the heater.
An air-source pool heat pump pulls heat from outdoor air. Its output and efficiency vary with air and water conditions, so compare equipment ratings at conditions close to those you expect. A water-to-water ground-source unit draws heat through a loop and can serve a pool through an appropriately designed heat exchanger. Compare the full system, including circulation pumps, rather than assuming a fixed efficiency or a guaranteed payback.
Think of it like this: You’re already paying to cool the house. If the pool also needs heat, why send all that heat away? For domestic hot water, some geothermal units offer a desuperheater, or hot water generator, to preheat water in a compatible tank. Pool water and potable water are separate loads. Ask a qualified designer to specify which heat exchangers, controls and backup equipment are needed for each.
Start by looking at how much heat the pool loses. The Department of Energy’s pool efficiency guide notes that a cover cuts evaporation, a major source of heat loss. Then compare solar, air-source and geothermal options for the same pool temperature, swimming season and cover use. If you already have a ground loop, ask whether it has capacity for the additional load before assuming it can heat the pool.
Jay Egg is a geothermal consultant and writer with Egg Geothermal. He co-authored two geothermal HVAC textbooks for McGraw Hill.
Updated content · November 17, 2026